From F21 drain faults to a dryer stuck on AF, we work on Whirlpool every week and carry the parts that fail most. Same-day slots most weekdays, and the diagnostic is free when you go ahead with the repair.
Phones answered 7am–11pm, seven days a week.
Whirlpool builds much of its range on shared platforms, so the same faults turn up again and again. These are the ones we see across Saskatoon.
Side-by-side and top-freezer fridges that stop cooling, ice up at the back panel, or leave water under the crisper.
Front-loaders showing F21, top-loaders that will not spin, and lids that will not lock to start.
Electric and gas dryers that tumble without heat, throw AF for airflow, or shut off early.
Electric and gas ranges that will not hold temperature, uneven bakes, and doors locked after self-clean.
Units leaving grit behind, water pooling in the base, or a cycle that stalls partway through.
Electric and gas cooktops with a burner out, and controls that stop responding.
A code points to the part Whirlpool thinks has failed. Some clear with a reset; the ones below usually mean a component needs replacing. Tell us the code when you book and we will bring the likely part.
Water did not clear within the time limit. Almost always the pump filter or a blocked hose; if those are clear, the drain pump.
The control cannot confirm the lock engaged. Check for anything in the latch area; if it closes clean, the lock has failed.
Water is trickling in too slowly. Check the taps and inlet screens; a failing inlet valve is the common repair.
Excess suds are stopping the spin. Usually non-HE detergent or too much of it; a persistent Sud can point to a drain issue.
The drum drains but never gets up to spin speed, leaving clothes soaked. Usually the motor or its control needs attention.
The dryer sees blocked airflow. Start with the lint screen and vent run; if those are clear, a sensor or the element may be at fault.
Codes vary by model and year, and the same code can have more than one cause. Treat this as a starting point, not a diagnosis — the only way to be sure is to open the machine up.
A few real Whirlpool jobs from around Saskatoon — what came in, what we did, and what it came to.
Rosewood. Dishes were coming out gritty and dirty water sat in the bottom after every cycle. The sump filter was packed and the drain pump had partly seized. We cleared the sump, fitted a new drain pump, and ran a cycle to confirm it drained clean.
Brighton. The oven would heat but never get up to the set temperature, so bakes came out underdone. The bake element had burned through at one end. We fitted a new bake element and checked the oven held temperature across a full preheat.
Sutherland. One burner on the gas cooktop clicked but would not light while the others were fine. The igniter had failed and the burner cap was fouled. We replaced the igniter, cleaned the assembly, and confirmed a clean light on every burner.
Each price shown is for that specific repair on that specific machine, including parts and labour. It is not a quote for your appliance — your cost depends on the model and the fault, and you get a firm price after the on-site diagnostic, before any work begins.
Wherever you are in the city, the technician who comes out is the one already closest, with the common Whirlpool parts in the van.
Just outside the city limits? Call and ask. We take jobs beyond the boundary when the schedule allows.
(639) 389-5241Leave your number and the model if you have it. We will call back with a two-hour window, and the diagnostic is free when you go ahead with the repair.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
We do not diagnose over the phone. A technician checks the machine on site, then quotes you before any work begins.
Your request has been sent. We will call you back shortly to confirm a time.
